By: Scott

Scott — Thu, 06 May 2021 01:13:03 +0000

Hi, I am currently hooking up a vacuum sealer that requires 6 cfm’s of air at 110 psi, the equipment will not complete it’s cycle & I believe the 1/4 npt FRC combo is causing the loss in pressure & the equipment drops to 90 psi in a dynamic running state. The equipment thus gets stuck in the middle of it’s cycle & cannot complete the sealing process because there is not enough vacuum being created. The house has 3-100 gallon compressors set at 135 psi the main piping is 1″ to the various departments & splits after the main into 1/4 npt size fittings & hoses. Will this piece of equipment require larger hoses & or FRC? Thx for any help, Scott

Comments on: What are sizing considerations for an FRL?

By: Scott